Giant RC DC-10 Turbine Powered Crashes Hard

Not a lot of MINOR …
Not a lot of MINOR crashes with these jet models, are there?

How big of an …
How big of an engine would you need to power that thing? Where do you get the engines for these type of aircraft?

when the left wing …
when the left wing stalled, the air flowing over that aleron stopped. The control imput at the time (left turn) became more powerful when only the right side control surfaces had significant control. The big mistake was after the pilot recovered out of the first steep turn. He tried to pull up to early, before there was enough airspeed to give enough lift. He pitched up immediately giving away all chance of saving the plane from its fall.

this airliners are …
this airliners are like jet fighters

Did the plane stall …
Did the plane stall? Looks like that.

crash and burn o …
crash and burn o yaaaaa

roflmao. hehe haha. …
roflmao. hehe haha. good one. love it.

A DC-10 crashing? …
A DC-10 crashing? That's unheard of!

best a tx shaker, …
best a tx shaker,not a stick shaker

He he, good point …
He he, good point lol!

…and the stick …
…and the stick shaker goes barrgghh…if they did have a stick shaker in radio Tx,the shaking will make the control too shaky and result…crash

Should have a stick …
Should have a stick shaker in the radio transmitter box….

Stalled going into …
Stalled going into the last turn……. Nice model! -M.

I believe so as …
I believe so as well. I know there is a kit manufacturer in Germany that does large r/c commercial, from boeing and airbus, but do not know the name of them. Theirs is all same scale as this. And then there is the guy who does has done a large scale C-17 as well.

lets check out the …
lets check out the black box and count how many survived….nice plane…5 stars

I believe this was …
I believe this was scratch built from balsa and plywood…

Could u tell me …
Could u tell me where did u buy it and which is the producer?

Did the AMA recover …
Did the AMA recover the black box to find out what happened?????? My guess is they found the YAW DAMP switches in the off position…….sad end to an amazing machine.

plz can i have …
plz can i have detaiols like engines and where u got base and stuff. size aswell

Tip stall.
Tip stall.

Well that's the …
Well that's the short of it, anyway. Tres triste. I'll quit yakkin' an' subscribe now.

Too steep a turn …
Too steep a turn with the reduced airspeed would do this. Not helping was the skidding, less-than-completely-coordinated turn. Just like in the full scale, just a few degrees of skid can blank your whole wing with disrupted airflow. He tried to recover and ran out of altitude. He should have had that nose down to make that turn regardless of where he intended to set the model down.

he stalled, because …
he stalled, because he exceeded the bank limit at the slower speed he was going, because he was entering into the pattern to land. as for 20 minutes, that doesn't matter. it depends on how much fuel and consumption the aircraft has.

I think it was …
I think it was because he over exceeded the flight limit, it should only be around 20 minutes.

Too bad it not made …
Too bad it not made so when its in a drop it would glide away from being in a crash would be able to control again.